CNZTL Taile

Technical Guide

Checking an AHU Selection Before You Accept the Price

Published 10 November 2026

Compare an AHU selection with your design inputs, clarify pressure and coil conditions, and check interfaces and exclusions before comparing quotations.

Compare the returned selection with your enquiry

Keep the design input sheet alongside the quotation and selection sheet. Check airflow, outside-air proportion, external static pressure, total and sensible cooling duty, entering and required leaving air conditions, and the specified heating or humidity-control functions. For chilled-water coils, compare the water temperatures and flow basis. For direct-expansion equipment, confirm the indoor and outdoor design conditions and the proposed system arrangement. Ask the supplier to identify any departure from your requested basis.

Check cooling duty on the same basis

Compare total and sensible capacity at the stated entering-air and water or refrigerant conditions. A nominal cooling capacity alone does not establish that the offered selection meets the project duty. Where humidity control is required, request the selected leaving-air condition and have the project designer review it against the room and process requirements. Record missing conditions before treating two quotations as equivalent.

Clarify the pressure boundary

Read airflow and external static pressure together. Ask where the external pressure boundary is defined and which filters, coils, silencers, hoods and other accessories are included in the fan pressure calculation. Their location and inclusion depend on the arrangement. Clarify the filter resistance used for selection and any allowance required by the design. A pressure value without a defined boundary is difficult to compare across suppliers.

Review coil configuration and moisture control

Ask for the selected coil arrangement, face velocity, air-side pressure drop and condensate provisions where relevant to the application. Review these with the stated cooling duty and leaving-air conditions. Coil row count alone does not establish dehumidification performance. Drainage, access and any carryover limits should be confirmed for the selected unit and operating conditions.

Ask for the required casing evidence

Compare the requested casing, insulation and access arrangement with the offered construction. Where the project specifies casing performance classes or a test standard, request evidence applicable to the offered unit and confirm its scope. Photographs and a general company certificate do not establish model-specific compliance. Outdoor and corrosive environments also need a separate review of materials, weather protection and installation conditions.

Reconcile electrical and control interfaces

Confirm voltage, phase, frequency, motor and drive arrangements, included sensors, control-panel scope and required interlocks. Identify the BMS interface and responsibility for integration. Distinguish equipment supplied by Taile from controls, wiring and integration provided by others. Any unresolved interface should remain visible in the scope comparison.

Check installation and maintenance space

Compare the arrangement drawing with the available plant space, delivery route and structural requirements. Confirm dimensions, weight, module splits, service side, filter and coil removal access, and drain connection arrangements. Approximate dimensions should be distinguished from approved drawings. Coordinate site connections and installation requirements with the responsible project contractor.

Compare exclusions before comparing totals

List the included equipment and options beside exclusions such as freight, unloading, lifting, site installation, ductwork, water piping, valves, controls integration and commissioning. A component shown in a reference drawing is not sufficient evidence that it is included. Resolve differences in duty, configuration and scope before drawing a conclusion from the price.

Keep unresolved items in one review list

Mark each difference as confirmed, revised or still requiring information. Request an updated selection and quotation where the agreed basis changes. This document review helps identify gaps; it does not replace engineering selection, project approval or agreed acceptance testing.

Discuss your equipment requirements with Taile

Send your equipment schedule, design conditions and layout drawings for review. The proposed configuration and supply scope will be confirmed for your enquiry.

Send an enquiry · Chat on WhatsApp · Prepare your selection inputs

Related reading

WhatsApp Send drawings Contact Kalyn