Technical Guide
Constant Temperature and Humidity Units: Preparing a Project Specification
Published 9 November 2026
Define the room conditions, loads and control requirements before selecting precision air conditioning.
Define the room requirement
Begin with the required room temperature and relative humidity, permitted variation and the location where compliance will be assessed. Describe operating hours, process activity and the outdoor design conditions. A general product description does not establish the performance of a particular selection.
Give the supplier a complete load picture
Provide sensible and latent loads, fresh-air requirements and relevant door-opening or infiltration assumptions. Include available electrical and water services, room drawings and equipment locations. The project designer should establish the design inputs; the equipment supplier can then review a selection against them.
Coordinate the control functions
Precision cooling equipment can combine cooling, dehumidification, reheat and humidification. The required functions depend on the application and selected configuration. Ask how these functions are controlled together, where temperature and humidity are sensed, and which alarms and monitoring interfaces are included. Confirm the water requirements if humidification is proposed.
Match the air path to the room
Upflow, downflow and ducted arrangements require different room layouts. Show the intended supply and return paths, any raised floor or ductwork, and maintenance clearances. Ask for the selected airflow and external static pressure, rather than assuming that a unit of the same nominal capacity will fit the same installation.
Agree the selection and verification basis
Request a model-specific equipment schedule stating the design conditions, supplied functions and exclusions. Define any project acceptance checks separately with the responsible parties. Temperature or humidity tolerances should be confirmed for the particular application rather than copied from a generic brochure.
Discuss your equipment requirements with Taile
Send your project location, equipment schedule, design conditions and layout drawings for an equipment selection review. The proposed scope and configuration will be confirmed for your enquiry.
Send an enquiry · Chat on WhatsApp · Prepare your selection inputs
Technical reading
These references explain general selection considerations; they do not certify Taile equipment or establish project-specific performance.
